RouterBOARD Troubleshooting: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
|||
| Line 1: | Line 1: | ||
This page describes methods of testing if a RouterBOARD device has troubles. Before contacting support, or RMA department, please carefully try ALL of the mentioned methods: | This page describes methods of testing if a RouterBOARD device has troubles. | ||
Before contacting support, or RMA department, | |||
please carefully try ALL of the mentioned methods: | |||
== Starts, but OS doesn't load == | == Starts, but OS doesn't load == | ||
Revision as of 15:38, 26 February 2007
This page describes methods of testing if a RouterBOARD device has troubles. Before contacting support, or RMA department, please carefully try ALL of the mentioned methods:
Starts, but OS doesn't load
- Check if the baud rate of your terminal program is set correctly, usually it's 9600 or 115000
- Try using mac-telnet, or mac-winbox to connect
- Make sure your RouterBOARD's BIOS is set to boot from NAND
- If all else fails, hold the button next to the LEDs to load backup BIOS
Starts, but an ERROR interrupts loading of RouterOS
- Enter the BIOS, set it to boot from ethernet, then NAND and reinstall OS with Netinstall. In most cases, it will not hurt the configuration or license.
- Examine the error message and see if it's meaning leads to a logical solution
- Contact support with the error message
No information on the console output
- Hold the button next to the LEDs to load backup BIOS
- Check if the baud rate of your terminal program is set correctly, usually it's 9600 or 115000
- Check Power jumpers, are they set according to the manual?