Manual:Interface/W60G: Difference between revisions
Jump to navigation
Jump to search
| Line 88: | Line 88: | ||
|type=string | |type=string | ||
|default= | |default= | ||
|desc= | |desc=Name of the interface | ||
}} | }} | ||
| Line 95: | Line 95: | ||
|type= | |type= | ||
|default=randomly generated | |default=randomly generated | ||
|desc= | |desc=Password used for AES encryption | ||
}} | }} | ||
Revision as of 13:20, 17 July 2017
Summary
Package: system
802.11ad implementation capable of providing Gigabit Ethernet speeds over wireless network.
Extend your gigabit network over a transparent AES encrypted wireless 60GHz link without usual wired or wireless network problems.
General interface properties
Sub-menu: /interface w60g
Devices comes in prefigured, connected pairs. Manual configuration is optional.
| Property | Description |
|---|---|
| arp (disabled | enabled | proxy-arp | reply-only; Default: enabled) | Read more >> |
| arp-timeout (auto | integer; Default: auto) | ARP timeout is time how long ARP record is kept in ARP table after no packets are recieved form IP. Value auto equals to value of arp-timeout in /ip settings, defoult is 30s. |
| comment (string; Default: ) | Short description of the interface |
| disabled (yes | no; Default: yes) | Whether interface is disabled |
| frequency (58320 | 60480 | 62640 | auto; Default: auto) | Frequency used in communication (Only active on master device) |
| l2mtu (integer [0..65536]; Default: 1600) | |
| mac-address (MAC; Default: ) | |
| mode (master | slave | sniff; Default: master) | Operation mode |
| mtu (integer [0..65536]; Default: 1500) | |
| name (string; Default: ) | Name of the interface |
| password (; Default: randomly generated) | Password used for AES encryption |
| ssid (string (0..32 chars); Default: value of system/identity) | SSID (service set identifier) is a name that identifies wireless network. |
Scan
Scan command allows to see available AP in the frequency range supported by W60G interface. Using scan command the interface operation is disabled (wireless link is disconnected during the scan operation)
Monitor
/interface w60g monitor wlan60-1
Monitor provides connection status, currently used frequency, remote device MAC address, mcs and signal quality. It's preferable to run monitor for easy device set up and aliment.