RouterOS has stateless IPv6 address autoconfiguration router-side support using Router Advertisement Daemon (RADVD). Prefixes of all addresses with 64 bit netmask are advertised by default.
General configuration
Sub-menu:/ipv6 nd
The menu contains one or more interface definitions on which router advertisement (RA) will be sent.
Each entry describes the information which is included in the RA of a specific interface.
Properties
Property
Description
advertise-dns (yes | no; Default: no)
advertise-mac-address (yes | no; Default: yes)
comment (string; Default: )
Descriptive name of an item
disabled (yes | no; Default: no)
Whether item is disabled or not. By default entry is enabled.
mtu (unspecified | integer[0..4294967295]; Default: unspecified)
The MTU option is used in router advertisement messages to insure that all nodes on a link use the same MTU value in those cases where the link MTU is not well known.
unspecified - do not send MTU option.
other-configuration (yes | no; Default: no)
ra-delay (time; Default: 3s)
The minimum time allowed between sending multicast router advertisements from the interface.
The time that a node assumes a neighbor is reachable after having received a reachability confirmation. Used by the Neighbor Unreachability Detection algorithm (see Section 7.3 of RFC 2461)
The time between retransmitted Neighbor Solicitation messages. Used by address resolution and the Neighbor Unreachability Detection algorithm (see Sections 7.2 and 7.3 of RFC 2461)
Prefix
Sub-menu:/ipv6 nd prefix
Properties
Property
Description
6to4-interface (none | string; Default: )
autonomous (yes | no; Default: yes)
comment (string; Default: )
Descriptive name of an item
disabled (yes | no; Default: no)
Whether item is disabled or not. By default entry is enabled.
