Routing Questions
Question: How does /ip route check-gateway work?
check-gateway sends pings every 10 seconds. if two successive pings fail, the gateway is considered dead.
Question: I have one /24 network advertised to two BGP peers using "/routing bgp networks" facility. How do I advertise a higher path cost to one of the peers?
You have to change the way you are redistributing your network, as filters are not applied to routes advertised from "/routing bgp networks". In most cases the network is connected directly to your router, so it's enough to set BGP instance to redistribute directly connected routes:
/routing bgp instance set default redistribute-connected=yes
- To filter out all other connected networks except the needed one, create a routing filter for the BGP instance,
/routing filter add invert-match=yes prefix=10.0.0.0/24 action=discard name=InstanceOutFilter
- then set filter "InstanceOutFilter" as the out-filter for "default" BGP instance.
/routing bgp instance set default out-filter=InstanceOutFilter
- To communicate a lower preference value (higher path cost) to one of the peers, you have to prepend your AS number multiple times to the BGP AS_PATH attribute
/routing filter add prefix=10.0.0.0/24 set-bgp-prepend=4 name=Peer1OutFilter /routing bgp peer set Peer1 out-filter=Peer1OutFilter
Question: I have a /22 (say 10.0.0.0/22) assigned IP space, split internally down into /30's, /28's, etc. Is it possible just to announce the /22 space via BGP with routing-test package?
Yes, it is possible. Do the following:
- 1. add an empty bridge interface:
/interface bridge add name=loopback
- 2. assign a /22 address to the bridge interface:
/ip address add address=10.0.0.1/22 interface=loopback
- 3. create a routing filter that filters out all prefixes except the /22 one
/routing filter add invert-match=yes prefix=10.0.0.0/22 prefix-length=22 action=discard name=myfilter
- 4. set filter "myfilter" as the out-filter for "default" BGP instance
/routing bgp instance set default out-filter=myfilter