Dual Setup with OSPF
In this setup we will be connecting a PTP configuration using a Dual Setup and OSPF (Open Shortest Path First).
The requirements for this set up is to have a board that supports at least 02 radios.
The advantages for this setup are:
- Double the maximum throuput with Full Duplex
- Automatic Failover
- No delay of packets. The same set up utilizing N-Streme-Dual can cause delay, which can be a problem if you're dealing with VoIP or applications that requires maximum response.
- This set up can make use of two radios at each end, so the availability becomes even more robust in case of a radio failure.
Configuring the Radio A:
/ip address add address=192.168.0.1/24 interface=ether1 /ip address add address=192.168.10.1/24 interface=wlan1 /ip address add address=192.168.20.1/24 interface=wlan2 /routing ospf network add network=192.168.10.0/24 area=backbone1 /routing ospf network add network=192.168.20.0/24 area=backbone1 /routing ospf interface add interface=wlan1 cost=100
Configuring the Radio B:
/ip address add address=192.168.0.2/24 interface=ether1 /ip address add address=192.168.10.2/24 interface=wlan1 /ip address add address=192.168.20.2/24 interface=wlan2 /routing ospf network add network=192.168.10.0/24 area=backbone1 /routing ospf network add network=192.168.20.0/24 area=backbone1 /routing ospf interface add interface=wlan2 cost=100
This set will cause the incoming traffic to use wlan1 on A and wlan2 on B.
This also will use any available path to get to the other side (Failover with OSPF).