View source for Dual Setup with OSPF

In this setup we will be connecting a PTP configuration using a Dual Setup and OSPF ([http://en.wikipedia.org/wiki/Open_Shortest_Path_First Open Shortest Path First]).<br>
The requirements for this set up is to have a board that supports at least 02 radios.<br>

The advantages for this setup are: <br>
* Double the maximum throuput with Full Duplex<br>
* Automatic Failover <br>
* No delay of packets. The same set up utilizing [http://wiki.mikrotik.com/wiki/Nstreme_dual_Step-by-Step N-Streme-Dual] can cause delay, which can be a problem if you're dealing with VoIP or applications that requires maximum response.<br>
* This set up can make use of two radios at each end, so the availability becomes even more robust in case of a radio failure.

[[Image:Full-duplex.gif]]

Configuring the Radio A:
 /ip address add address=192.168.0.1/24 interface=ether1
 /ip address add address=192.168.10.1/24 interface=wlan1
 /ip address add address=192.168.20.1/24 interface=wlan2
 /routing ospf network add network=192.168.10.0/24 area=backbone1
 /routing ospf network add network=192.168.20.0/24 area=backbone1
 /routing ospf interface add interface=wlan1 cost=100

Configuring the Radio B:
 /ip address add address=192.168.0.2/24 interface=ether1
 /ip address add address=192.168.10.2/24 interface=wlan1
 /ip address add address=192.168.20.2/24 interface=wlan2
 /routing ospf network add network=192.168.10.0/24 area=backbone1
 /routing ospf network add network=192.168.20.0/24 area=backbone1
 /routing ospf interface add interface=wlan2 cost=100

This set will cause the incoming traffic to use wlan1 on ''A'' and wlan2 on ''B''.<br>
This also will use any available path to get to the other side (Failover with OSPF).<br>