Logging SNR and thruput values

This script logs the radio name, system identity, system uptime, board name, firmware version, clients connected, ccq, nstreme, frequency etc. etc.

It is extremely useful for debugging wireless problems, like intermittent noise, signal and ccq. Use the following script on a schedule. Configure the mikrotik to log data to a syslog server and you have a powerful way of monitoring your equipment.

Tested and works with version 3.12 and up.

#AP STATS
:foreach i in=[/interface wireless find ] do={/interface wireless monitor $i once do { :log info ( "int=" . [/int wire get $i name] . "," . [/system identity get name] . "," . [/system resour get uptime] . "," . [/system reso get board-name] ."," . [/system reso get version] . "," .$"registered-clients" .  ",".  $"overall-tx-ccq" . "." . $"nstreme" . "," . $"rx-ccq" . "," . $"noise-floor" . ","  . $"frequency" . "," . $"band" . "," . [/int wire get $i ssid] .  "," . [/int wire get $i ack-timeout] .  "," . [/int wire get $i hw-retries] .  "," . [/int wire get $i wds-mode]  . "," . $"tx-rate" . "," . $"rx-rate" . "," . $"signal-strength" . "," . $"tx-signal-strength")}}

#CLIENTS CONNECTED
/int wire reg
:foreach i in=[ /int wir reg find] do={:log info ([/system identity get name] . "," . [get $i  mac-address ]. "," . [get $i last-ip] . "," . [get $i rx-rate] . "," . [get $i tx-rate] . "," . [get $i uptime] . "," . [get $i last-activity] . "," . [get $i signal-strength] . "," . [get $i signal-to-noise] . "," . [get $i tx-ccq] . "," . [get $i bytes] . "," . [get $i packets])}

2.x firmware version

:local interface "wlan1";
/interface wireless monitor $interface once do={
:local signal $"signal-strength";
:local snr $"signal-to-noise";
:local noise $"noise-floor";
:local thruput $"p-throughput";
:local freq $"frequency";
:log info "SNR: $snr Signal $signal Noise: $noise , thruput: $thruput , freq: $freq MHz";
};