Manual:BGP Best Path Selection Algorithm

From MikroTik Wiki
Revision as of 19:13, 26 September 2006 by Eugene (talk | contribs)
Jump to: navigation, search

Introduction

Routers running Border Gateway Protocol (BGP) typically receive multiple paths to the destination. The BGP best path selection algorithm decides which is the best path to instal in the IP routing table and use for forwarding traffic.

Why Routers Ignore Paths

A router running BGP arranges all paths for the same prefix in a list that is later used to select the best path. Some paths in this list are not considered for the best path selection algorithm. Routers ignore paths in the following circumstances:

  • Paths from an external BGP (eBGP) neighbor if the local autonomous system (AS) appears in the AS_PATH attribute.
Such paths are not even installed in the BGP Routing Information Base (RIB) and thus do not consume memory. The same applies to any path that is discarded (action=discard) by the routing filters.

How Routers Select the best Path

  • Prefer the path with the highest WEIGHT.
WEIGHT parameter is local to the router on which it is configured. A route without assigned WEIGHT have a default value of 0.
A path without LOCAL_PREF have a value of 100 by default.
  • Prefer the path with the shortest AS_PATH. (skipped if ignore-as-path-len set to yes)
The router does not compare AS_PATH length if ignore-as-path-len parameter is set to yes for the respective BGP instance. Each AS_SET counts as 1, regardless of the set size. The AS_CONFED_SEQUENCE and AS_CONFED_SET are not included in the AS_PATH length.
  • Prefer the path with the lowest origin type.
Interior Gateway Protocol (IGP) is lower than Exterior Gateway Protocol (EGP), and EGP is lower than INCOMPLETE
  • Prefer the path with the lowest multi-exit discriminator (MED).
The router compare MED only for paths that have the same neighboring (leftmost) AS. Paths with now MED are assigned a MED of 0
  • Prefer eBGP over iBGP paths
  • Prefer the route that comes from the BGP router with the lowest router ID
  • Prefer the path that comes from the lowest neighbor address