Manual:Interface/Gre

From MikroTik Wiki
< Manual:Interface
Revision as of 12:40, 21 August 2014 by Strods (talk | contribs) (Arp note)
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
Version.png

Applies to RouterOS: v5+

Summary

Sub-menu: /interface gre
Standards: GRE RFC 1701


GRE (Generic Routing Encapsulation) is a tunnelling protocol that was originally developed by Cisco. It can encapsulate a wide variety of protocols creating a virtual point-to-point link.

GRE is the same as IPIP and EoIP which were originally developed as stateless tunnels. Which means that if the remote end of the tunnel goes down, all traffic that was routed over the tunnels will gets blackholed. To solve this problem, RouterOS have added 'keepalive' feature for GRE tunnels.

GRE tunnel adds a 24 byte overhead (4-byte gre header + 20-byte IP header).


Icon-note.png

Note: {{{1}}}


Properties

Property Description
comment (string; Default: ) Short description of the tunnel.
disabled (yes | no; Default: no) Enables/disables tunnel.
dscp (inherit | integer [0-63]; Default: ) Since v5.6, set dscp value in GRE header to a fixed value or inherit from dscp value taken from tunnelled traffic
keepalive (integer [1..4294967295]; Default: ) Tunnel keepalive timeout in seconds. By default keepalive is disabled.
l2mtu (integer [0..65536]; Default: 65535) Layer2 Maximum transmission unit.
local-address (IP; Default: 0.0.0.0) IP address that will be used for local tunnel end. If set to 0.0.0.0 then IP address of outgoing interface will be used.
mtu (integer [0..65536]; Default: 1476) Layer3 Maximum transmission unit.
name (string; Default: ) Name of the tunnel.
remote-address (IP; Default: ) IP address of remote tunnel end.

Setup examples

The goal of this example is to get Layer 3 connectivity between two remote sites over the internet. Site-to-site-gre-example.png

We have two sites, Site1 with local network range 10.1.101.0/24 and Site2 with local network range 10.1.202.0/24.

First step is to create GRE tunnels. Router on site 1:

/interface gre add name=myGre remote-address=192.168.90.1 local-address=192.168.80.1

Router on site 2:

/interface gre add name=myGre remote-address=192.168.80.1 local-address=192.168.90.1

As you can see tunnel configuration is quite simple.

Icon-note.png

Note: In this example keepalive is not configured, so tunnel interface will have running flag even if remote tunnel end is not reachable



Now we just need to set up tunnel addresses and proper routing. Router on site 1:

/ip address 
  add address=172.16.1.1/30 interface=myGre

/ip route 
  add dst-address=10.1.202.0/24 gateway=172.16.1.2

Router on site 2:

/ip address 
  add address=172.16.1.2/30 interface=myGre

/ip route 
  add dst-address=10.1.101.0/24 gateway=172.16.1.1

At this point both sites have Layer 3 connectivity over GRE tunnel.

[ Top | Back to Content ]