Difference between revisions of "Manual:Interface/W60G"

From MikroTik Wiki
Jump to: navigation, search
m (General interface properties)
(General interface properties)
Line 88: Line 88:
|desc=name of the interface
|desc=Name of the interface
Line 95: Line 95:
|default=randomly generated
|default=randomly generated
|desc=password used for AES encryption
|desc=Password used for AES encryption

Revision as of 14:20, 17 July 2017


Package: system

802.11ad implementation capable of providing Gigabit Ethernet speeds over wireless network.

Extend your gigabit network over a transparent AES encrypted wireless 60GHz link without usual wired or wireless network problems.

General interface properties

Sub-menu: /interface w60g

Devices comes in prefigured, connected pairs. Manual configuration is optional.

Property Description
arp (disabled | enabled | proxy-arp | reply-only; Default: enabled) Read more >>
arp-timeout (auto | integer; Default: auto) ARP timeout is time how long ARP record is kept in ARP table after no packets are recieved form IP. Value auto equals to value of arp-timeout in /ip settings, defoult is 30s.
comment (string; Default: ) Short description of the interface
disabled (yes | no; Default: yes) Whether interface is disabled
frequency (58320 | 60480 | 62640 | auto; Default: auto) Frequency used in communication (Only active on master device)
l2mtu (integer [0..65536]; Default: 1600)
mac-address (MAC; Default: )
mode (master | slave | sniff; Default: master) Operation mode
mtu (integer [0..65536]; Default: 1500)
name (string; Default: ) Name of the interface
password (; Default: randomly generated) Password used for AES encryption
ssid (string (0..32 chars); Default: value of system/identity) SSID (service set identifier) is a name that identifies wireless network.


Scan command allows to see available AP in the frequency range supported by W60G interface. Using scan command the interface operation is disabled (wireless link is disconnected during the scan operation)


/interface w60g monitor wlan60-1

Monitor provides connection status, currently used frequency, remote device MAC address, mcs and signal quality. It's preferable to run monitor for easy device set up and aliment.