Difference between revisions of "Manual:Interface/W60G"

From MikroTik Wiki
Jump to: navigation, search
m (Summary)
m (General interface properties)
Line 32: Line 32:
 
|type= auto {{!}} integer
 
|type= auto {{!}} integer
 
|default=auto
 
|default=auto
|desc=ARP timeout is time how long ARP record is kept in ARP table after no packets are recieved form IP. Value '''auto''' equals to value of '''arp-timeout''' in '''/ip settings''', default is 30s
+
|desc=ARP timeout is time how long ARP record is kept in ARP table after no packets are received form IP. Value '''auto''' equals to the value of '''arp-timeout''' in '''/ip settings''', default is 30s
 
}}
 
}}
  

Revision as of 13:28, 17 July 2017

Summary

Package: system

802.11ad implementation capable of providing Gigabit Ethernet speeds over wireless network.

Extend your Gigabit network over a transparent AES encrypted wireless 60GHz link without usual wired or wireless network problems.

General interface properties

Sub-menu: /interface w60g

Devices comes in prefigured, connected pairs. Manual configuration is optional.

Property Description
arp (disabled | enabled | proxy-arp | reply-only; Default: enabled) Read more >>
arp-timeout (auto | integer; Default: auto) ARP timeout is time how long ARP record is kept in ARP table after no packets are received form IP. Value auto equals to the value of arp-timeout in /ip settings, default is 30s
comment (string; Default: ) Short description of the interface
disabled (yes | no; Default: yes) Whether interface is disabled
frequency (58320 | 60480 | 62640 | auto; Default: auto) Frequency used in communication (Only active on master device)
l2mtu (integer [0..65536]; Default: 1600)
mac-address (MAC; Default: )
mode (master | slave | sniff; Default: master) Operation mode
mtu (integer [0..65536]; Default: 1500)
name (string; Default: ) Name of the interface
password (; Default: randomly generated) Password used for AES encryption
ssid (string (0..32 chars); Default: value of system/identity) SSID (service set identifier) is a name that identifies wireless network

Scan

Scan command allows to see available AP in the frequency range supported by W60G interface. Using scan command the interface operation is disabled (wireless link is disconnected during the scan operation)

Monitor

/interface w60g monitor wlan60-1

Monitor provides connection status, currently used frequency, remote device MAC address, mcs and signal quality percentage. It's preferable to run monitor for easy device set up and aliment.