https://wiki.mikrotik.com/index.php?title=Manual:Interface/W60G/GUIexample&feed=atom&action=historyManual:Interface/W60G/GUIexample - Revision history2024-03-28T21:46:27ZRevision history for this page on the wikiMediaWiki 1.38.2https://wiki.mikrotik.com/index.php?title=Manual:Interface/W60G/GUIexample&diff=33412&oldid=prevAntonsb: Created page with "{{Versions|v6.43.4+}} ==Summary== This example shows how to configure transparent wireless bridge in GUI from one W60G device to another. Example is done from empty configu..."2019-06-28T09:03:27Z<p>Created page with "{{Versions|v6.43.4+}} ==Summary== This example shows how to configure transparent wireless bridge in GUI from one W60G device to another. Example is done from empty configu..."</p>
<p><b>New page</b></p><div>{{Versions|v6.43.4+}}<br />
<br />
==Summary==<br />
<br />
This example shows how to configure transparent wireless bridge in GUI from one W60G device to another.<br />
<br />
Example is done from empty configuration state with [[https://mikrotik.com/download WinBox]] utility<br />
<br />
==Connect to the device==<br />
<br />
After configuration reset - only mac-telnet is possible. In main WinBox screen press on Neighbours, choose your devices MAC address and press Connect:<br />
<br />
[[File:winbox_main_screen.png]]<br />
<br />
<br />
==Configure bridge==<br />
<br />
Add new bridge and assign bridge members to it. This will allow to pass traffic from from Ethernet to W60G interface without routing. Open Bridge submenu, press on "+" to add new bridge and apply your changes:<br />
<br />
[[File:create_bridge1.png]]<br />
<br />
Add interface members (ether1 and wlan60-1) to newly created bridge. Pres on Ports submenu and add new member with "+", select correct interfaces and add to bridge created previously:<br />
<br />
[[File:create_bridge2.png]]<br />
<br />
==Set up wireless connection==<br />
<br />
All previously explained steps are identical to Master and Slave devices. When configuring wireless interface different modes needs to be used.<br />
<br />
Configure master device as follows:<br />
*) open Interface menu, <br />
*) double click on wlan60-1 interface<br />
*) under Wireless submenu set mode to ```"bridge"```, set SSID and password, select previously created bridge under "Put Stations In Bridge"<br />
*) Apply your changes and press on enable to start transmitting<br />
*) in interface submenu wlan60-1 from greyed out will become active<br />
<br />
[[File:w60g_bridge.png]]<br />
<br />
For Slave device - <br />
*) open Interface menu, <br />
*) double click on wlan60-1 interface<br />
*) under Wireless submenu set mode to ```"station-bridge"```, set SSID and password<br />
*) Apply your changes and press on enable to start transmitting<br />
*) in interface submenu wlan60-1 from greyed out will become active<br />
<br />
[[File:w60g_station.png]]<br />
<br />
==Additional configuration==<br />
<br />
Link should be established after all previously explained steps are done.<br />
It's recommended to set up administrators password on both devices.</div>Antonsb