Manual:Reset: Difference between revisions

From MikroTik Wiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 6: Line 6:
== Reset from RouterOS ==  
== Reset from RouterOS ==  


If you still have access to your router and want to recover its default configuration, then you can run command "/system reset-configuration" from command line interface or do it from "System/Reset Configuration" menu in graphical user interface.
If you still have access to your router and want to recover its default configuration, then you can run command '''"/system reset-configuration"''' from command line interface or do it from '''System -> Reset Configuration''' menu in graphical user interface.


== Button reset ==  
== Button reset ==  

Revision as of 08:20, 7 March 2019

Icon-note.png

Note: RouterOS password can only be reset by reinstalling the router, or using the reset button (or jumper hole) in case the hardware is RouterBOARD. For X86 devices, only complete reinstall will clear the password, along with other configuration. For RouterBOARD devices, several methods exist, depending on our model.


Reset from RouterOS

If you still have access to your router and want to recover its default configuration, then you can run command "/system reset-configuration" from command line interface or do it from System -> Reset Configuration menu in graphical user interface.

Button reset

Most RouterBOARD devices are fitted with a reset button.

Using: unplug the device from power, press and hold the button right after applying power and hold the button for 5 seconds (USER LED will start flashing). Now release the button to clear configuration.

Note: If you wait until LED stops flashing, and only then release the button - this will instead launch Netinstall mode, to reinstall RouterOS.

262 hi res.png

Note: More reset button functions can be found in https://wiki.mikrotik.com/wiki/Manual:Reset_button

Jumper hole reset

All RouterBOARD current models are also fitted with a reset jumper hole. Some devices might need opening of the enclosure, RB750/RB951/RB751 have the jumper hole under one of the rubber feet of the enclosure.

Using: Close the jumper with a metal screwdriver, and boot the board until the configuration is cleared.

Resethole.jpg

Passw.jpg

Jumper reset for older models

The below image shows the location of the Reset Jumper on older RouterBOARDs like RB133C:

CRW 5184.jpg

Note: Don't forget to remove the jumper after configuration has been reset, or it will be reset every time you reboot.