Manual:Reset

From MikroTik Wiki
Revision as of 06:11, 9 April 2010 by Normis (talk | contribs)
Jump to navigation Jump to search

RouterOS password can only be reset by reinstalling the router, or using the reset jumper (or jumper hole) in case the hardware is RouterBOARD. For RouterBOARDS just close the jumper and boot the board until the configuration is cleared. For some RouterBOARDs there is not a jumper, but a jumper hole - just put a metal object into the hole, and boot the board.

Resethole.jpg

Passw.jpg

For older models

The below image shows the location of the Reset Jumper on older RouterBOARDs like RB133C:

CRW 5184.jpg

Note: Don't forget to remove the jumper after configuration has been reset, or it will be reset every time you reboot.