Hardware that supports monitoring will display different information about hardware status, like temperature, voltage, current, fan-speed, etc.
Example on CCR1072-1G-8S+ device:
cpu-overtemp-check: yes cpu-overtemp-threshold: 100C cpu-overtemp-startup-delay: 1m cpu-temperature: 46C power-consumption: 62.9W board-temperature1: 31C board-temperature2: 34C psu1-voltage: 12.1V psu2-voltage: 0V psu1-current: 5.2A psu2-current: 0A fan1-speed: 6375RPM fan2-speed: 6436RPM fan3-speed: 6375RPM fan4-speed: 6467RPM
Routers that support voltage monitoring will display supplied voltage value. In CLI/Winbox it will display volts. In scripts/API/SNMP this will be dV or value showed in CLI/Winbox multiplied by 10
Routers that support temperature monitoring will display temperature reading. In CLI/Winbox it will display degrees Celsius. Using scripts/API/SNMP this value will be shown in CLI/Winbox multiplied by 10. There are various temperature sensors depending on the device. These sensors may refer to: cpu-temperature, pcb-temperature, sfp-temperature.
Fan control and behaviour
/system health set
Using this menu users will be able to control fan behaviour on TILE architecture devices. Currently, for other RouterBOARD devices, there is no option to manually control FAN behaviour.
There are three parameters that may affect fan behaviour: PoE-out consumption, SFP temperature and CPU temperature. As soon as one of the parameters exceeds the optimal value the, fans are started.
If a device has PoE-out, then the fan RPM will change as described below:
|PoE-out load||RPM % of max FAN speed (DC fans)|
|0%..24%||FAN speed 0%|
|25%..46%||FAN speed 25%|
|47%..70%||FAN speed 50%|
|71%..92%||FAN speed 75%|
|93%..||FAN speed 100%|
For devices with PWM fans, the speed will linearly increase or decrease from 9..88% (note: below 100W the fan RPM=0)
CPU and SFP temperature
If CPU or SFP temperatures exceed 58C, the fans will start to spin. The higher the temperature, the faster the fans will spin. For devices with PWM fans, as the CPU or SFP temperatures exceed 58C, the fans will linearly increase their RPM to try to keep the temperature at 58C if possible. For devices with DC fans, as the CPU or SFP temperatures exceed 58C, the fans will start spinning but at a higher minimum RPM by default. This may result in cooling the device to the point where the fans turn-off completely. After which the temperature may slowly increase to 58C and the fans will turn on again. Currently, there is one exception. The S+RJ10 modules have a temperature threshold of 65C before they trigger the fans. Since it's a higher temperature threshold, the fans will start spinning at a higher initial speed to cool the device.