Manual:Wireless FAQ: Difference between revisions

From MikroTik Wiki
Jump to navigation Jump to search
No edit summary
Line 22: Line 22:
====Will an amplifier improve the speed on my link?====
====Will an amplifier improve the speed on my link?====


It depends on your signal quality and noise.
It depends on your signal quality and noise. Remember that you can probably get a better link with low output power setting, and a good antenna. Amplifier increases the noise and will only cause problems with the link.

Revision as of 10:16, 26 May 2008

Settings

What is CCQ and how are the values determined?

Client Connection Quality (CCQ) is a value in percent that shows how effective the bandwidth is used regarding the theoretically maximum available bandwidth. CCQ is weighted average of values Tmin/Treal, that get calculated for every transmitted frame, where Tmin is time it would take to transmit given frame at highest rate with no retries and Treal is time it took to transmit frame in real life (taking into account necessary retries it took to transmit frame and transmit rate).

What is hw-retries setting?

Number of times sending frame is retried without considering it a transmission failure. Data rate is decreased upon failure and frame is sent again. Three sequential failures on lowest supported rate suspend transmission to this destination for the duration of on-fail-retry-time. After that, frame is sent again. The frame is being retransmitted until transmission success, or until client is disconnected after disconnect-timeout. Frame can be discarded during this time if frame-lifetime is exceeded.

What is disconnect-timeout setting?

This interval is measured from third sending failure on the lowest data rate. At this point 3 * (hw-retries + 1) frame transmits on the lowest data rate had failed. During disconnect-timeout packet transmission will be retried with on-fail-retry-time interval. If no frame can be transmitted successfully during diconnect-timeout, connection is closed, and this event is logged as "extensive data loss". Successful frame transmission resets this timer.

What is adaptive-noise-immunity setting?

Adaptive Noise Immuinty (ANI) adjusts various receiver parameters dynamically to minimize interference and noise effect on the signal quality [1] This setting is added in the wireless driver for Atheros AR5212 and newer chipset cards

Setups

Will an amplifier improve the speed on my link?

It depends on your signal quality and noise. Remember that you can probably get a better link with low output power setting, and a good antenna. Amplifier increases the noise and will only cause problems with the link.