Difference between revisions of "PTP Links - A Step By Step Guide"

From MikroTik Wiki
Jump to: navigation, search
Line 14: Line 14:
 
Start by opening the Mikroitk Metal 5SHPN through Winbox. then You will see WLAN listed here, they might be disabled - to turn them on, click on the blue Enable button. Make sure that the interface is configured and the antennas are connected before you enable an interface.
 
Start by opening the Mikroitk Metal 5SHPN through Winbox. then You will see WLAN listed here, they might be disabled - to turn them on, click on the blue Enable button. Make sure that the interface is configured and the antennas are connected before you enable an interface.
 
[[File:1.JPG]]
 
[[File:1.JPG]]
 +
 +
To configure an interface, double-click on WLAN, and the config window will appear. To set the device as an Bridge mode, choose "bridge" mode. You can also set other things, like the desired band, frequency, SSID and the security profile. also chose nv2 protocol for better throughput.

Revision as of 15:50, 7 May 2013

Bridge & Station WDS

This article will show a very quick overview for beginners on setting up a Point to Point link in Router OS Winbox graphical configuration tool.

Requirements :-

1. 2 Nos of Mikrotik Metal 5SHPN. 2. 30 dbi Grid antenna make KBT.

Instructions

a) Configuration Bridge End Device

Start by opening the Mikroitk Metal 5SHPN through Winbox. then You will see WLAN listed here, they might be disabled - to turn them on, click on the blue Enable button. Make sure that the interface is configured and the antennas are connected before you enable an interface. 1.JPG

To configure an interface, double-click on WLAN, and the config window will appear. To set the device as an Bridge mode, choose "bridge" mode. You can also set other things, like the desired band, frequency, SSID and the security profile. also chose nv2 protocol for better throughput.