Difference between revisions of "PTP Links - A Step By Step Guide"

From MikroTik Wiki
Jump to: navigation, search
Line 1: Line 1:
[[Bridge & Station WDS]]  
+
[[AP Bridge & Station WDS]]  
  
 
This article will show a very quick overview for beginners on setting up a Point to Point link in Router OS Winbox graphical configuration tool.
 
This article will show a very quick overview for beginners on setting up a Point to Point link in Router OS Winbox graphical configuration tool.
Line 10: Line 10:
 
[[Instructions]]
 
[[Instructions]]
  
'''a) Configuration Bridge End Device'''
 
  
Start by opening the Mikroitk Metal 5SHPN through Winbox. then You will see WLAN listed here, they might be disabled - to turn them on, click on the blue Enable button. Make sure that the interface is configured and the antennas are connected before you enable an interface.
+
Start by opening the Mikroitk Metal 5SHPN through Winbox. then You will see WLAN listed here, they might be disabled - to turn them on, click on the blue Enable button. Make sure that the interface is configured and the antennas are connected before you enable an interface. this configure for only AP device.  
 
[[File:1.JPG]]
 
[[File:1.JPG]]
  
  
To configure an interface, double-click on WLAN, and the config window will appear. To set the device as an Bridge mode, choose "bridge" mode. You can also set other things, like the desired band, frequency, SSID and the security profile. also chose nv2 protocol for better throughput.
+
To configure an interface, double-click on WLAN, and the config window will appear. To set the device as an Bridge mode, choose "AP bridge" mode. You can also set other things, like the desired band, frequency, SSID and the security profile. also chose nv2 protocol for both end for better throughput.
 
[[File:13.JPG]]
 
[[File:13.JPG]]
 +
 +
 +
Then add a bridge and add ether1 & wlan1 in bridge port. also add both end device.
 +
[[File:15.JPG]]
 +
[[File:16.JPG]]
 +
 +
Then create WDS in AP end device.
 +
[[File:18.JPG]]

Revision as of 16:29, 7 May 2013

AP Bridge & Station WDS

This article will show a very quick overview for beginners on setting up a Point to Point link in Router OS Winbox graphical configuration tool.

Requirements :-

1. 2 Nos of Mikrotik Metal 5SHPN. 2. 30 dbi Grid antenna make KBT.

Instructions


Start by opening the Mikroitk Metal 5SHPN through Winbox. then You will see WLAN listed here, they might be disabled - to turn them on, click on the blue Enable button. Make sure that the interface is configured and the antennas are connected before you enable an interface. this configure for only AP device. 1.JPG


To configure an interface, double-click on WLAN, and the config window will appear. To set the device as an Bridge mode, choose "AP bridge" mode. You can also set other things, like the desired band, frequency, SSID and the security profile. also chose nv2 protocol for both end for better throughput. 13.JPG


Then add a bridge and add ether1 & wlan1 in bridge port. also add both end device. 15.JPG 16.JPG

Then create WDS in AP end device. 18.JPG