Difference between revisions of "Private Management Network with Vlans Using minimial Configuration"

From MikroTik Wiki
Jump to: navigation, search
Line 11: Line 11:
  
 
Bind Two ports WLAN1 and Ether1
 
Bind Two ports WLAN1 and Ether1
 +
 +
Your Management IP address can be on Ether1 or bridge
  
  
Line 23: Line 25:
 
Bridge Ether1 to BridgevlanXX
 
Bridge Ether1 to BridgevlanXX
 
Bridge Vlan to BridgvlanXX
 
Bridge Vlan to BridgvlanXX
 +
 +
For the Management of this device you can leave the 192.168.88.1 on ether1
 +
 +
You will have to make sure your Managment ip address is on WLAN 1  (For Private Management)

Revision as of 03:18, 1 February 2012

To create a Private Management Network for the Mikrotik Devices.

Also allowing Vlans to pass through the AP to the CPE's and have the CPE untag (access mode) to Customer equipment.


On Access Point:

Ensure it's setup in AP-Bridge mode

Create a Bridge

Bind Two ports WLAN1 and Ether1

Your Management IP address can be on Ether1 or bridge


On CPE Station

Ensure it's setup in Station-Bridge mode

Create vlan and bind it to WLAN1

Create BridgevlanXX

Bridge Ether1 to BridgevlanXX Bridge Vlan to BridgvlanXX

For the Management of this device you can leave the 192.168.88.1 on ether1

You will have to make sure your Managment ip address is on WLAN 1 (For Private Management)