RouterBOARD Troubleshooting: Difference between revisions

From MikroTik Wiki
Jump to navigation Jump to search
No edit summary
Line 3: Line 3:
== Starts, but OS doesn't load ==
== Starts, but OS doesn't load ==


* Check if the baud rate of your terminal program is set correctly
* Check if the baud rate of your terminal program is set correctly, usually it's 9600 or 115000
* Try using mac-telnet, or mac-winbox to connect
* Try using mac-telnet, or mac-winbox to connect
* Make sure your RouterBOARD's BIOS is set to boot from NAND
* Make sure your RouterBOARD's BIOS is set to boot from NAND

Revision as of 13:33, 26 February 2007

This page describes methods of testing if a RouterBOARD device has troubles. Before contacting support, or RMA department, please carefully try ALL of the mentioned methods:

Starts, but OS doesn't load

  • Check if the baud rate of your terminal program is set correctly, usually it's 9600 or 115000
  • Try using mac-telnet, or mac-winbox to connect
  • Make sure your RouterBOARD's BIOS is set to boot from NAND
  • If all else fails, hold the button next to the LEDs to load backup BIOS

No information on the console output

  • Hold the button next to the LEDs to load backup BIOS