Difference between revisions of "UPnP Multi-WAN"

From MikroTik Wiki
Jump to: navigation, search
m
m
Line 10: Line 10:
  
 
Same script easier to read with syntax colorization:
 
Same script easier to read with syntax colorization:
forum.mikrotik.com/viewtopic.php?p=426711#p426711
+
 
 +
'''forum.mikrotik.com/viewtopic.php?p=426711#p426711'''
  
  

Revision as of 10:24, 18 May 2014

1. Make the simplest UPnP config for just WAN1.

2. Add the following script: will clone UPnP NAT entries from WAN1 as normal NAT entries for WAN2: (Schedule every few minutes) (set <WAN2 IP> manually)


global UPnPs [/ip fi nat find dynamic]; :if ($UPnPs != $UPnPz) do={ :global UPnPz; :set $UPnPz $UPnPs; /ip fi nat remove [/ip fi nat find comment="UPnP_Cloned"]; :foreach i in=([/ip fi nat find dynamic]) do={/ip fi nat add chain=dstnat dst-address="<WAN 2 IP>" protocol=[/ip fi nat get $i protocol] to-addresses=[/ip fi nat get $i to-addresses] to-ports=[/ip fi nat get $i to-ports] action=dst-nat dst-port=[/ip fi nat get $i dst-port] comment="UPnP_Cloned"}}


Same script easier to read with syntax colorization:

forum.mikrotik.com/viewtopic.php?p=426711#p426711


3. For large networks you may find it useful to clean any Dynamic NAT entries and cloned NAT entry every other night, as old ones may pile up:

/ip firewall nat remove [/ip firewall nat find comment="UPnP_Cloned"]