Wireless Matrix

From MikroTik Wiki
Revision as of 13:13, 19 October 2011 by SergejsB (talk | contribs) (Wireless Feature Applicability Matrix: Update for other protocols)
Jump to: navigation, search

Feature Matrix General Information

  • Feature Matrix indicates wireless network type when specific feature can be used.
  • Note that there are 2 columns for 802.11 protocol: 802.11 specifies availability of mode in "pure" 802.11 network (when connecting to any vendor AP) and ROS 802.11 specifies availability of mode when connecting to RouterOS AP that implements necessary proprietary extensions for mode to work.

Wireless Feature Applicability Matrix

Icon-note.png

Note: This table at the moment has only correctly selected NV2 features, rest of the columns are not filled


802.11 ROS 802.11 nstreme nv2
adaptive-noise-immunity V V V V
allow-sharedkey V V V
antenna-gain V V V V
antenna-gain V V V V
antenna-mode V V V V
area V V V V
arp V V V V
band V V V V
basic-rates-a/g V V V V
basic-rates-b V V V V
bridge-mode V V V V
burst-time
channel-width V V V V
comment V V V V
country V V V V
default-ap-tx-limit V V V V
default-authentication V V V V
default-client-tx-limit V V V V
default-forwarding V V V V
dfs-mode V V V V
disable-running-check V V V V
disabled V V V V
disconnect-timeout V V V
distance V V
frame-lifetime V V
frequency V V V V
frequency-mode V V V V
hide-ssid V V V
ht-ampdu-priorities V V
ht-amsdu-limit V V V
ht-amsdu-threshold V V
ht-basic-mcs V V V V
ht-guard-interval V V V V
ht-rxchains V V V V
ht-supported-mcs V V V V
ht-txchains V V V V
hw-fragmentation-threshold V V
hw-protection-mode V V
hw-protection-threshold V V
hw-retries V V V
l2mtu V V V V
mac-address V V V V
master-interface V V V
mac-address V V V V
max-station-count V V V V
mode V V V V
mtu V V V V
name V V V V
noise-floor-threshold V V V V
nv2-cell-radius V
nv2-noise-floor-offset V
nv2-preshared-key V
nv2-qos V
nv2-queue-count V
nv2-security V
on-fail-retry-time V V V
periodic-calibration V V V
periodic-calibration-interval V V V
preamble-mode V V V
prism-cardtype V V
proprietary-extensions V V V V
radio-name V V V V
rate-selection V V V V
rate-set V V V V
scan-list V V V V
security-profile V V V *
ssid V V V V
station-bridge-clone-mac V V V
supported-rates-a/g V V V V
supported-rates-b V V V V
tx-power V V V V
tx-power-mode V V V V
update-stats-interval V V V
wds-cost-range V V V V
wds-default-bridge V V V V
wds-default-cost V V V V
wds-ignore-ssid V V V
wds-mode V V V V
wireless-protocol V V V V
wmm-support V V V

* - Nv2 protocol uses different security configuration.

WDS Applicability Matrix

The following matrix specifies possible WDS network setups for each wireless-protocol. First column specifies possible WDS network structure.

ROS 802.11 nstreme nv2
AP-bridge* to AP-bridge V
AP-bridge to Station-WDS V V V
AP-bridge to WDS-Slave V

* - mode=ap-bridge applies to mode=bridge too.

Station Applicability Matrix

The following matrix specifies station modes available for each wireless-protocol.

802.11 ROS 802.11 nstreme nv2
station V V V V
station-wds V V V
station-pseudobridge V V V
station-pseudobridge-clone V V V
station-bridge V V V

More information about stations mode configuration.