S+RJ10 general guidance

From MikroTik Wiki
Jump to navigation Jump to search

Summary

MikroTik S+RJ10 is a unique 6-speed RJ-45 SFP+ module that is based on a Marvell 88X3310P transceiver. It offers up to 10 Gbps speeds using twisted-pair copper cables. All of the current MikroTik devices that have an SFP+ cage support the S+RJ10 module. This article serves as a guideline of the S+RJ10 usage in MikroTik devices with both passive or active cooling.

General Guidance

Product specification

The average power consumption of the transceiver is 2.7 W (10GBASE-T, 30 m link) which is relatively high comparing with S+85DLC03D optical module with maximum 0.8W power consumption. The operating temperature is 0 to +70 C, but the transceiver itself can heat up to 90 C.

S+RJ10 Positioning in devices

Due to high operating temperatures, it is recommended to use S+RJ10 transceivers while optical transceiver or an unused SFP+ interface is in between them. Take a look on the transceivers capable distance comparison table.

Alt text
Recommended S+RJ10 placement
Alt text
We do not recommend to place transceivers side by side
As mentioned, S+RJ10 heat up more than regular transceivers and keeping them side by side can result in overheating, especially in devices with 4 linear SFP cages. It is recommended to place S+RJ10 in every second interface with keeping an optical transceiver or an empty port in between them.
Even when using devices that come with separated SFP+ cages, for example CRS309-1G-8S+, it is still not recommended to deploy the S+RJ10 transceivers beside each other. Use S+RJ10 in every second interface to avoid transceivers overheating which may cause unpredictable behavior.
Alt text
Recommended S+RJ10 placement
Alt text
It is not recommended to place transceivers side by side
Alt text
Recommended S+RJ10 placement
Alt text
We do not recommend to place transceivers side by side
Devices that come with 4 or 8 block SFP+ cages are not exceptions. It is recommended to use one S+RJ10 transceiver per 4xSFP+ cage block and avoided placing them side by side. Keep at least one vertical row empty(without S+RJ10) after plugged S+RJ10 transceiver.

Using the S+RJ10 Side by Side or with passive cooling devices

There might be situations when it is not possible to use the recommended layout of the transceivers. In such cases where two or more S+RJ10 transceivers are plugged in beside one another or modules are used in passive cooling devices, the network administrator has to ensure additional cooling. The air flow around the device should be increased or the overall ambient temperature should be lowered to keep the temperature of the transceivers within the recommended range.