Difference between revisions of "Private Management Network with Vlans Using minimial Configuration"

From MikroTik Wiki
Jump to: navigation, search
m
 
Line 1: Line 1:
To create a Private Management Network for the Mikrotik Devices.
+
To create a Private Management Network for the Mikrotik Devices. Also allowing Vlans to pass through the AP to the CPE's and have the CPE untag (access mode) to Customer equipment.
  
Also allowing Vlans to pass through the AP to the CPE's and have the CPE untag (access mode) to Customer equipment.
+
'''On Access Point'''
  
 +
*Ensure it's setup in AP-Bridge mode
 +
*Create a Bridge
 +
*Bind Two ports WLAN1 and Ether1
 +
*Your Management IP address can be on Ether1 or bridge
  
On Access Point:
+
'''On CPE Station'''
  
Ensure it's setup in AP-Bridge mode
+
*Ensure it's setup in Station-Bridge mode
 +
*Create vlan and bind it to WLAN1
 +
*Create BridgevlanXX
 +
*Bridge Ether1 to BridgevlanXX
 +
*Bridge Vlan to BridgvlanXX
  
Create a Bridge
+
For the Management of this device you can leave the 192.168.88.1 on ether1. You will have to make sure your Managment ip address is on WLAN 1  (For Private Management).
 
 
Bind Two ports WLAN1 and Ether1
 
 
 
Your Management IP address can be on Ether1 or bridge
 
 
 
 
 
On CPE Station
 
 
 
Ensure it's setup in Station-Bridge mode
 
 
 
Create vlan and bind it to WLAN1
 
 
 
Create BridgevlanXX
 
 
 
Bridge Ether1 to BridgevlanXX
 
Bridge Vlan to BridgvlanXX
 
 
 
For the Management of this device you can leave the 192.168.88.1 on ether1
 
 
 
You will have to make sure your Managment ip address is on WLAN 1  (For Private Management)
 
 
 
 
 
And of course a Visio Diagram for better viewing :)  Enjoy!
 
  
 
[[File:Mikrotik-Simple.jpg]]
 
[[File:Mikrotik-Simple.jpg]]

Latest revision as of 12:27, 8 February 2012

To create a Private Management Network for the Mikrotik Devices. Also allowing Vlans to pass through the AP to the CPE's and have the CPE untag (access mode) to Customer equipment.

On Access Point

  • Ensure it's setup in AP-Bridge mode
  • Create a Bridge
  • Bind Two ports WLAN1 and Ether1
  • Your Management IP address can be on Ether1 or bridge

On CPE Station

  • Ensure it's setup in Station-Bridge mode
  • Create vlan and bind it to WLAN1
  • Create BridgevlanXX
  • Bridge Ether1 to BridgevlanXX
  • Bridge Vlan to BridgvlanXX

For the Management of this device you can leave the 192.168.88.1 on ether1. You will have to make sure your Managment ip address is on WLAN 1 (For Private Management).

Mikrotik-Simple.jpg

Created by: Dejan Dan Protich Sago Networks, LLC. dprotich_sagonet_com